Corner Radius Endmill 8 mm in 0.5 and 1 mm radius pack of 1 CNCCARBIDEINSERT and turning operations for finishing

and turning operations for finishing and roughing purposes

Please note this is not for RPMT10T3

whereby a pattern of straight

APKT11T308 is equivalent to the ZCCCT carbide insert and can be used in the same cutter

Run out tolerance is maintained by grinding by center to center

Corner Radius Endmill 8 mm in 0.5 and 1 mm radius pack of 1 CNCCARBIDEINSERT and turning operations for finishingA Corner radius endmill End Mill is usually used to add a specific radius to a workpiece, to remove a sharp edge or burr or to use in some finishing operation Most cutters are available with 0. 5 mm, 1 mm, 1. 5 mm, or 2 or 3 mm radii. Please choose as per the requirement.